Sliding fittings

Nacházíte se:

Sliding fittings

On request

BBB

--%>

The POS movable fitting with a notched ring is an accessory designed for installation of temperature sensors with 3–8 mm diameters into thermowells, boreholes and various systems (gearboxes, bearings, etc.), and allows you to adjust a required immersion depth of the sensor in the measured medium. The movable fitting can be made of stainless steel of grade DIN 1.4301 (AISI 304), DIN 1.4571 (AIS 316Ti). The fitting consists of three parts – mounting fitting for securing in a measured point, a notched sealing ring and a cap nut to tighten the ring. The selected immersion depth cannot be changed anymore after the tightening. The inner diameter of the movable fitting is always bigger by 0.1–0.2 mm than the sensor diameter.

Sizes, materials and threads of the movable fitting can be changed if required by the customer.

Technické parametry

Fitting specification	Sensor diameter	Mounting fitting					Total length after tightening L
Fitting specification	Sensor diameter	Thread type	Thread length L1	Size OK	Thread type	Size OK1	Total length after tightening L
POS 30	3 mm	M 8x1	10 mm	12	M 8x1	12	35 mm
POS 30	3 mm	M 10x1,5	10 mm	14	M 8x1	12	35 mm
POS 30	3 mm	G 1/4"	10 mm	17	M 12x1	17	35 mm
POS 40	4 mm	M 8x1	10 mm	12	M 8x1	12	35 mm
POS 40	4 mm	M 10x1,5	10 mm	14	M 8x1	12	35 mm
POS 40	4 mm	G 1/4"	10 mm	17	M 12x1	17	35 mm
POS 60	6 mm	M 10x1,5	10 mm	14	M 8 x1	12	35 mm
POS 60	6 mm	M 12x1,5	10 mm	17	M 12x1	17	35 mm
POS 60	6 mm	M 20x1,5	15 mm	24	M 12x1	17	40 mm
POS 60	6 mm	G 1/2"	15 mm	24	M 12x1	17	40 mm
POS 80	8 mm	M 12x1,5	10 mm	17	M 12x1	17	35 mm
POS 80	8 mm	G 3/8	15 mm	22	M 12x1	17	40 mm
POS 80	8 mm	M 20x1,5	15 mm	24	M 12x1	17	40 mm
POS 80	8 mm	G 1/2"	15 mm	24	M 12x1	17	40 mm