extend Your senses
sitemap
cz en Lithuania
A selected group of goods  Products »

TG 80, TG 81 and TG 82
diameter 8 mm, -50 °C to 400 °C

Description and application

TG 80, TG 81 and TG 82
diameter 8 mm, -50 °C to 400 °C

These resistance sensors are primarily designed for temperature measurement of solid substances, but can also be used for temperature measurement of liquids or gaseous substances. To mount the sensor to the measuring point, a bayonet nut is used that is screwed on a spring. The combination of a bayonet nut, spring and corresponding bayonet connector can provide higher contact pressure of the sensor to the measuring point or correct any changes in the distance between the nut and measuring point during measurement. The maximum temperature range of the sensors is - 50 to 350 °C (short-term 400 ° C). The range for individual design variations is narrowed down by the type of temperature sensing element and supply cable. The sensors meet the level of protection from IP 50 to IP 67 according to EN 60529, depending on the type of lead-in cable. The sensors are designed to operate in a non-aggressive environment. The method of use must be chosen with regard to temperature and chemical resistance of the case and lead-in cable.

ACCESSORIES

DECLARATION, CERTIFICATION, CALIBRATION

  • Manufacturer provides EU Declaration of Conformity.
  • Calibration – The final metrological inspection – comparison with standards or working instruments – is carried out for all the products. Continuity of the standards and working measuring instruments is ensured within the meaning of the Section 5 of Act no.505/1990 on metrology. The manufacturer offers a possibility to supply the sensors calibrated in SENSIT s.r.o.’s laboratory (according to requirements of the EN ISO/IEC 17025 standard) or in an Accredited laboratory.  

  • Specifications
  • Wiring diagram
  • Dimensional draft
  • Download
Sensor type TG 80 TG 81 TG 82
Case end straight semisphere R8 apex 120°
Sensing element all types
(Pt 100, Pt 1000, Ni 1000, Ni 10000,Ni 2226=T1, NTC, PTC, KTY,
TSiC, DALLAS, thermocouple K, thermocouple J, thermocouple T and so on)
Case material stainless steel DIN 1.4301
Diameter of case 8 mm
Length of case 10 to 85 mm (with addition of 15 mm for cable attachment)
Lead-in cable variations/
Temperature range
(can be limited by type of sensing element
– determine in documentation)
PVC shielded -30 to 80 °C
PVC unshielded -40 to 105 °C
silicone shielded -50 to 200 °C
teflon shielded -50 to 250 °C
with fibreglass 0 to 400 °C
(with metal braiding)
Ingress protection PVC and silicone cables IP 67
teflon cables IP 64 accordance with EN 60529
cables with glass fibre IP 50
Material/Dimension of bayonet nut nickel-plated brass /L = 18 mm, inner Ø 15 mm
Material/Dimension of spring stainless steel DIN 1.4301
/L = 200 mm, outer Ø 8 mm, Ø of wire 0.9 mm
Insulation resistance 200 MΩ at 500 V DC
Maximum permissible static pull on the lead-in cable 1 kg

Note: Manufacturer reserves the right to make changes in design and technical characteristics of the products. For actual information, please always contact your dealer.

Datasheet - temperature sensor with bayonet
Datasheet - temperature sensor with bayonetDatasheet - temperature sensor with bayonet
Schéma zapojení
Rozměrový náčrt

Back to category